INSTALLATION, COMMISSIONING & Dismantling
Professional installation by qualified and experienced staff

Our staff then checks the installed systems for compliance with requirements. In mutually performed test runs we then determine how well the projected capacity can be fulfilled. Our highly qualified employees carry out the mechanical and electrical fine-tuning necessary for commissioning the systems.
After delivery of the equipment and machines, they will be assembled and commissioned by our experienced electric & mechanical technicians and specialists. The scope of our activities depends on your needs and can range from small service calls, through supervised assembly (monitoring and technical direction) to complete installation. Over the entire setting-up period our experts shall always assume full responsibility for the equipment and shall always be at your side when needed.

Installation and Start-up on Site
- The installation and the on-site start-up consist of correct positioning, putting on the line, and connection to your installation, and verifying that the equipment has not suffered damage during transport. The final settings and adjustments are then made. A Site Acceptance Tests (SAT) protocol may be followed to formalize this final phase of the project.
Tests and Commissioning
- In the first place, a power-up is operated after a general conformity check with design specifications, for example, electrical diagrams. Then the automation engineer executes I/O test sequences on each sensor, each actuator, and all hardware connected to the machine. The PLC program then starts the debugging phase. In parallel, the trimmer finalizes any alterations and starts the mechanical adjustment of the machine.
Dismantling and Relocation
The disassembly of production lines and accessories as well as infrastructure (heating, cooling, compressors) is carried out by our well-trained staff with years of experience
The disassembly process is coordinated in advance with the client to allow, if necessary, ongoing production to continue simultaneously with the disassembly of the production line. As part of disassembly, everything is documented, i.e. the individual parts are labeled logically and photographed in detail. Removal of the machines and components is specific to the buildings and is coordinated with the client.
Following or during disassembly, the machines, and parts – if necessary – are packed in boxes or loaded directly onto lorries or put in shipping containers. During this process, care is always taken so that, on the one hand, as few modes of transport are used as possible (containers, lorries) and, on the other hand, there is no risk of damage during transport. We prepare all necessary documents and packing lists for each type of transport.











